Tesla Inc is issuing two recalls covering about 9,500 vehicles for roof trim that may separate and bolts that may not have been properly tightened.
The larger recall covers 9,136 Model X cars from the 2016 model year, the National Highway Traffic Safety Administration (NHTSA) said on Wednesday.
NHTSA said the front and spine cosmetic roof trim may have been adhered without first using primer, and one or both pieces of trim may separate from the vehicle while it is being driven.
Tesla said in documents filed with the agency it learned in September of an event involving a 2016 Model X that prompted a company investigation into the root cause and frequency of the condition that could create a road hazard for motorists behind the vehicle.
(Also read | Tesla fights back against reports of suspension defect, blames China for recall)
Tesla will inspect the recalled vehicles and apply a retention test. If they fail, Tesla will apply primer to remedy the condition.
The other recall covers 401 2020 model year Tesla Model Y vehicles with bolts connecting the front upper control arm and steering knuckle that may not have been properly tightened. Due to the inadequate tightening, NHTSA said the upper control arm could detach from the steering knuckle.
Tesla said it recently learned of three vehicle repairs where the upper control arm had separated.
It said vehicles would be inspected for proper torque and if necessary, would be adjusted.
Tesla said it was not aware of any accidents or injuries tied to either recall.
This story has been published from a wire agency feed without modifications to the text.